What materials can be marked by 355nm DPSS UV laser marking machine

The UV laser marking machine is a technology very different from CO2 and Fiber laser technology. Today we are going to explain the main differences between this technologies.

 

Cold laser engraving

 

Also knows as the blue laser beam, this technology has the capacity of engraving with a low rate of heat. The light wave or UV light spectrum of this machine is one of the main reasons this technology can engrave over different materials because it doesn’t heat the material surface as the Fiber and the CO2 does. It allows the UV laser mark clear and with high precision over all the plastics and other materials that have an adverse reaction with heat.

 

Plastics laser marking

 

There are thousands of different mix of plastics, and all of them can be engraved for UV laser technology, these are some of the most common plastics engraving with our laser engraver machine.

 

Polyethylene (PE)

Polyvinyl Chloride (PVC)

Polypropylene (PP)

Polystyrene (PS)

Polylactic Acid (PLA)

Polycarbonate (PC)

Acrylic (PMMA)

Acetal (Polyoxymethylene, POM)

Nylon (PA)

ABS (Acrylonitrile Butadiene Styrene)

Other Plastic not mention here.

Metals laser mark

 

The UV laser it can engrave and mark metals, but not always with the same effect as the fiber laser engraver machine. While a fiber laser can etch over the metal surface with deep effect and with a clear result, the UV laser has problems engraving metals covered with painting, or metals highly reflective like the copper. Check below the list of metals that the UV laser can engrave.

Aluminium 

Gold

Platinum

Silver

Titanium

Brass 

Stainless steel

Crome

Wood

 

The UV laser is a full crossover technology, ideal for overall engraving plastics and some common metals. However, one of the significant advantages of this machine comes at the time to engrave some non-metal materials like wood. This machine can make amazing engravings on different wood surfaces. It can’t make deep and fast etching as a CO2 galvanometer laser, but it can produce a light and beautiful marking result.

 

Mahogany

Walnut

Oak

Ash

Birch

Maple

Cherry

Pine

Spruce

Cedar

Fir

Larch

MDF

Plywood

Fibreboard

Garments

Our UV laser machines also can engrave some garments, especially if the garments are rich in synthetic fibers. However, if you want to engrave in specific clothing, we can run a test to check the engraving results before you purchase our machine.

 

Glass laser mark

 

UV 레이저는 재료를 깨지거나 과열시키지 않고 유리 표면에 새길 수 있는 기술 중 하나입니다. 파편 유리 결과 없이 놀라운 조각과 패턴을 만들 수 있습니다. 

 

종이 및 판지 레이저 마크

 

골판지 조각도 재료에 따라 다르며 결과는 일반적인 CO2 기계 조각과 다릅니다. CO2 기계가 판지 또는 종이 재료의 표면을 탄화시키는 동안 UV는 재료 표면에 표시를 만드는 화학 반응을 생성합니다. 그렇기 때문에 판지 표면에 흰색으로 조각할 수 있습니다. 검은색 마분지에 여전히 명확한 대비를 얻을 수 있습니다. 이 재료의 각인에 대해 더 궁금한 점이 있으면 저희에게 연락하십시오.